Conveyor Finished Product Checklist
Mechanical
___ ___ ___ FULL WIDTH RANGE (2-18”) AVAILABLE
___ ___ ___ TRANSFER RAILS: SQUARED / PARALLEL / HEIGHT
___ ___ ___ WORKSTATION INSTALLED
___ ___ ___ COVERS – VERIFY CONSISTENCY AMONG COVERS FOR ALL CONVEYORS ON THE ORDER
___ ___ ___ AC TSD ASSY INSTALLED & FREE SLIDING
___ ___ ___ VERIFY ROLLERS DO NOT BIND
___ ___ ___ PUSHER INSTALLED AND FUNCTIONAL
___ ___ ___ PULLEY GUARDS MOUNTED
___ ___ ___ INTERFACE BRACKETS ATTACHED
Electrical
___ ___ ___ HIPOT TEST: RESULT_________ <5 mA TECHNICIAN ______________________
___ ___ ___ GROUND CONTINUITY RESULT ____________________________< 0.17 OHM
___ ___ ___ DRY CYCLE RUN COMPLETE – 1 HOUR
___ ___ ___ “INSPECT” INSTALLED AND OPERABLE, VERIFY CORRECT LOCATION
___ ___ ___ “E-STOP(S)”, “ERROR(S)” INSTALLED AND OPERABLE
___ ___ ___ MIDRANGE MOTORS (11.5:1), IDLER PULLEYS (FREE SPINNING)
___ ___ ___ IF SMEMA INTERFACE, BE SURE SMEMA INTERFACE CABLE IS INCLUDED
___ ___ ___ VERIFY SPEED ADJ RANGE
___ ___ ___ VERIFY X-FORMER IS NOT NOISY
___ ___ ___ FUSE LABEL APPLIED ON CANADIAN ORDERS ONLY
Hardware
___ ___ ___ LEVELING PADS LOCKED DOWN
___ ___ ___ HARDWARE TIGHTENED (LEGS, WIDTH SUPPORTS, RAILS)
Functional
___ ___ ___ VERIFY BOARD TRANSFER (SMEMA FUNCTIONALITY)
