Installation Of The Insertion Head Assembly

To install the insertion head assembly, proceed as follows.

1.Power down the machine and perform Lockout/Tagout according to local procedures.


2.Align the assembly from the back of the insertion head driver assembly and install the pusher onto the bottom of the main shaft.

3.Close the shaft clamp (1).

4.Install the tooling pin (2) and secure it with the set screw (3).

5.Tighten the socket set screw (4).

6.Tighten the hex jam nut (5).



                 End of procedure

Write a Comment

Your email address will not be published.