45798401 Tube Continuity to save Auto Insertion machine running cost

 

 

45798407 Tube Continuity

45798406 Tube Continuity

45798405 Tube Continuity

45798404 Tube Continuity

45798403 Tube Continuity

45798402 Tube Continuity

45798401 Tube Continuity

 

 

Preventive Maintenance Schedule

 

WARNING Do not perform any preventive maintenance with power on unless specifically instructed otherwise. Failure to observe this warning may result in personal injury.

 

CAUTION When performing machine maintenance, wear a wrist strap connected to ground to prevent electrostatic discharge damage to printed circuit boards.

 

500,000 Cycles Check: Perform Maintenance:

  1. Clean the clinch scrap tube with the pipe cleaner (40940101) twice daily (every 250,000 cycles).

 

3,000,000 Cycles Check: Perform Maintenance:

  1. Check for excessive wear on the pins 1. Lubricate the cutter linkage pins with Magnalube and linkage. Replace if necessary. (40833809).

 

12,000,000 Cycles Check: Perform Maintenance:

Check for worn cutters and bushings on 1. Replace if necessary. the cut and clinch by observing the quality of the production board component leads. 2. Lubricate the clinch lead screw with Super Blue (BLKM07680). 3. Replace the O-rings and bumpers in the cutter cylinders on the cut and clinch assembly. 4. Lubricate the three surfaces of the notch in the rocker guide Kendall Super Blue (BLKM07680).

48,000,000 Cycles Check: Perform Maintenance: 1. Lubricate the anvil slides with Kendall Super Blue (40833838) and grease gun (47408201).