Tag Archives: Scrap tape cutter

SMT,THT,PCB,PCBA,AI,wave soldering,reflow oven,nozzle,feeder,wave soldering

SMT Reel Scrap Tape cutter operating introduction

Functional description
The Scrap Tape Cutter is designed to cut off small pieces of reel

tape and collect them in a trash bin for ease of disposal.

Prodcut safety

• Do not put objects other than reel tape in the cutter unit.
• Use caution with long hair and when wearing loose clothing
near the cutter unit.
• Unplug the unit when performing maintenance of the
machine.
• Do not operate the machine near flammable gas.
• Do not open/disassemble the cutter unit while the machine
is operating.
• Follow all safety labels on the cutter unit.

Automatic Mode

1. Rotate the Emergency Stop switch.
2. Push [ON] button at AUTO. The blade unit begins to move.
The blade continues to cycle until the collection bin is
removed or the Emergency Stop switch is pushed.

Recover From Jam

Use the following procedure to clear a jam.
1. Push the Emergency Stop switch to stop the buzzer.
2. Rotate the Emergency Stop switch.
3. Turn power on by pushing [ON] button at POWER.
4. Push and hold the Left or Right Directional Arrow button to
move the blade back away from the jam.
5. Push the Emergency Stop switch and clear the jam.
6. Rotate the Emergency Stop switch.
7. Turn power on by pushing [ON] button at POWER.
8. Push [ON] button at AUTO. Resume auto cutting.

Empty the Trash Bin

Use the following procedure when emptying the Scrap Tape Cutter
collection bin.

1. Grasp the handles on the trash bin and slide the bin out from
the Scrap Tape Cutter unit. The cutter automatically stops.
2. Empty and then re-install the trash bin. Push the [ON] button
at AUTO to resume operation.


Replace the Blades
The blade unit of the Scrap Tape Cutter consists of a fixed and hex blade.
Replace both blades when the cutter jams frequently or when the blades
become damaged or worn. Use the following procedure when replacing the
cutter blades.
1. Push the Emergency Stop switch and unplug the unit.
2. Remove the back cover and tape inlet guide from the cutter unit.
3. Remove the 4 screws that secure the fixed blade to the housing. Use
caution so as not to lose the washers that are under the blade.


4. Remove the idler guide from the housing.
5. Remove the 6 screws that secure the hex blade to the housing.
6. Clean any debris that may have gathered under the blades.
7. Install the new hex blade. Note the correct orientation of the blade.
8. Install the idler guide and secure to the housing.
9. Verify that the washers are in place and install the new fixed blade.
10. Install the tape inlet guide making certain the plate is aligned with the
screw holes.
11. Install the back cover, plug in the unit, and rotate the Emergency Stop
switch. The unit is ready for operation.


SMT reel tape cutter,THT,PCB,PCBA,reflow ovenSMT,LED,PCBA,PCB,THT,AI